"IM " CNS Standards List| Low Voltage | Method test | Identification Cards | Throat Plates | Sanitary ceramic | Method Determining | Erasers | Mounted Wheels | |
|
CNS 15027-2
2019 Edition Sound system equipment − Headphones and earphones associated with personal music players − MaxIMum sound pressure level measurement methodology − Part 2: Matching of sets with headphones if either or both are offered separately, or are offered as one pack 聲音系統設備－與個人音樂播放器相關之頭戴式耳機及耳戴式耳機－最大聲壓位準量測法－第2部：個人音樂 播放器與頭戴式耳機之匹配－兩者單獨提供或以套裝設備提供 |
|
|
|
CNS 15027-3
2019 Edition Sound system equipment − Headphones and earphones associated with personal music players − MaxIMum sound pressure level measurement methodology − Part 3: Measurement method for sound dose management 聲音系統設備－與個人音樂播放器相關之頭戴式耳機及耳戴式耳機－最大聲壓位準量測法－第3部：聲音劑量管理之量測法 |
|
|
|
CNS 14676-4
2019 Edition Electromagnetic compatibility(EMC) − Testing and measurement techniques − Part 4: Electrical fast transient/burst IMmunity test 電磁相容－測試與量測技術－第4部：電性快速暫態/叢訊的抗擾度測試 |
|
|
|
CNS 17190-6
2019 Edition Urine-absorbing aids for incontinence − Test methods for characterizing polymer-based absorbent materials − Part 6: GravIMetric determination of fluid retention capacity in saline solution after centrifugation 尿失禁用尿液吸收輔具－聚合物吸收材料特性試驗法－第6部：經離心後於生理食鹽水中保留液體能力之重量測定法 |
|
|
|
CNS 14676-3
2019 Edition Electromagnetic compatibility (EMC) − Testing and measurement techniques – Part 3: Radiated, radio-frequency, electromagnetic field IMmunity test 電磁相容－測試與量測技術－第3部：輻射、射頻與電磁場抗擾度測試 |
|
|
|
CNS 14705-1
2019 Edition Method of test for heat release rate for building materials – Part 1: Cone calorIMeter method 建築材料燃燒熱釋放率試驗法－第1 部：圓錐量熱儀法 |
|
|
|
CNS 17190-8
2019 Edition Urine-absorbing aids for incontinence − Test methods for characterizing polymer-based absorbent materials − Part 8: GravIMetric determination of flowrate 尿失禁用尿液吸收輔具－聚合物吸收材料特性試驗法－第8部：流率之重量測定法 |
|
|
|
CNS 8048
2019 Edition Spices and condIMents – Nomenclature 香辛料及調味料－名稱 |
|
|
|
CNS 14432-1
2019 Edition Determination of the ultIMate aerobic biodegradability of plastic materials under controlled composting conditions − Method by analysis of evolved carbon dioxide − Part 1: General method 塑膠材料在控制堆肥條件下最終好氧生物分解度測定法－二氧化碳釋出量分析法－第1部：一般方法 |
|
|
|
CNS 14934-3
2019 Edition Electromagnetic compatibility (EMC) - LIMits - Part 3: Limitation of voltage changes, voltage fluctuations and flicker in public low-voltage supply systems, for equipment with rated current ≦16A per phase and not subject to conditional connection 電磁相容－限制值－第3部：每相額定電流在16 A以下且不屬於有條件連接之設備於公共低電壓電源系統中電壓改變、電壓變動及閃爍之限制值 |
|
|
|
CNS 15027-1
2019 Edition Sound system equipment − Headphones and earphones associated with personal music players − MaxIMum sound pressure level measurement methodology − Part 1: General method for one package equipment 聲音系統設備－與個人音樂播放器相關之頭戴式耳機及耳戴式耳機－最大聲壓位準量測法－第1部：套裝設備之一般量測法 |
|
|
|
CNS 8912
2019 Edition Method of abrasion test for building materials and part of building construction (Method of abrasion test for flooring materials method with rotating disk fitted friction and IMpact) 建築材料及建築組件磨耗試驗法(旋轉圓盤之摩擦及衝擊地板材料之磨耗試驗法) |
|
|
|
CNS 14934-2
2019 Edition Electromagnetic compatibility (EMC) - LIMits - Part 2: Limits for harmonic current emissions (equipment input current ≦16A per phase) 電磁相容－限制值－第2部：諧波電流發射（設備每相輸入電流在16 A以下）之限制值 |
|
|
|
CNS 14959
2019 Edition LIMits for exposuring to time-varying electric, magnetic and electromagnetic fields (up to 300 GHz) 時變電場、磁場及電磁場曝露之限制值（３００ＧＨｚ以下） |
|
|
|
CNS 60335-2-114
2019 Edition Household and sIMilar electrical appliances − Safety − Part 2-114: Particular requirements for self-balancing personal transport devices for use with batteries containing alkaline or other non-acid electrolytes 家用和類似用途電器－安全性－第2-114部：搭配含鹼性或其他非酸性電解質電池組使用之自主平衡式個人運輸裝置之個別規定 |
|
|
|
CNS 60669-2-3
2019 Edition Switches for household and sIMilar fixed electrical installations − Part 2-3: Particular requirements − Time-delay switches (TDS) 家用和類似用途固定式電氣裝置之開關－第2-3部：延時開關(TDS)之個別要求 |
|
|
|
CNS 16121-2
2019 Edition Electrical apparatus for the detection of combustible gases in domestic premises − Part 2: Electrical apparatus for continuous operation in a fixed installation in recreational vehicles and sIMilar premises − Additional test methods and performance requir 家居處所可燃氣體偵測用之電氣裝備－第2部：固定裝設於休旅車船及類似處所之持續操作用電氣裝備－附加試驗方法及性能要求 |
|
|
|
CNS 8465-2
2019 Edition Acoustics - Rating of sound insulation in buildings and of building elements - IMpact sound insulation 聲學－建築物及建築構件之隔音量評定－衝擊音隔音 |
|
|
|
CNS 11031
2019 Edition Structural glued-laminated tIMber 結構用集成材 |
|
|
|
CNS 13306-2-3
2019 Edition Specification for radio disturbance and IMmunity measuring apparatus and methods - Part 2-3: Methods of measurement of disturbances and immunity - Radiated disturbance measurements 射頻擾動和免疫力量測設備與量測方法－第２－３部：擾動和免疫力量測方法－輻射擾動量測 |
|
|
|
CNS 60335-2-40
2019 Edition Household and sIMilar electrical appliances − Safety − Part 2-40: Particular requirements for electrical heat pumps, air-conditioners and dehumidifiers 家用和類似用途電器－安全性－第2-40部：電熱泵、空氣調節機及除濕機之個別規定 |
|
|
|
CNS 13306-1-1
2019 Edition Specification for radio disturbance and IMmunity measuring apparatus and methods - Part 1-1: Radio disturbance and immunity measuring apparatus - Measuring apparatus 射頻擾動和免疫力量測設備與量測方法－第１－１部：射頻擾動和免疫力量測設備－量測設備 |
|
|
|
CNS 60669-2-5
2019 Edition Switches for household and sIMilar fixed electrical installations – Part 2-5: Particular requirements – Switches and related accessories for use in home and building electronic systems (HBES) 家用和類似用途固定式電氣裝置之開關－第2-5部：住宅及建築物電子系統(HBES)用開關及相關配件之個別要求 |
|
|
|
CNS 3801
2019 Edition Method of test for splitting tensile strength of cylindrical concrete specIMens 混凝土圓柱試體劈裂抗張強度試驗法 |
|
|
|
CNS 16107-3
2019 Edition Hollow taper interface with flange contact surface − Part 3: DIMensions of shanks for stationary tools 具凸緣接觸面之空心錐度界面－第3部：固定式刀具之刀柄尺度 |
|
|
|
CNS 14674-2
2019 Edition Electromagnetic compatibility (EMC) - Generic standards - Part 2: IMmunity industrial environments 電磁相容性（ＥＭＣ）－一般性標準－第２部：工業環境之免疫力 |
|
|
|
CNS 14004
2019 Edition Environmental management systems − General guidelines on IMplementation 環境管理系統－實施之一般指導綱要 |
|
|
|
CNS 13306-1-5
2019 Edition Specification for radio disturbance and IMmunity measuring apparatus and methods - Part 1-5: Radio disturbance and immunity measuring apparatus - Antenna calibration test sites for 30 MHz to 1000 MHz 射頻擾動和免疫力量測設備與量測方法－第１－５部：射頻擾動和免疫力量測設備－30 MHz至 1000 MHz之天線校正場地 |
|
|
|
CNS 4392
2019 Edition Plastics − Determination of charpy IMpact properties − Part 2: Instrumented impact test 塑膠－彎曲性能測定法 |
|
|
|
CNS 13783-2
2019 Edition Electromagnetic compatibility – Requirements for household appliances, electric tools and sIMilar apparatus – Part 2: Immunity – Product family 電磁相容性－家用電器、電動工具及類似裝置之要求－第2 部：耐受力－產品族系 |
|
| Find out:1245Items | To Page of: First -Previous-Next -Last | [9] [10] [11] [12] [13] [14] [15] |
