"5 " CNS Standards List |
|
CNS 14485
2018 Edition Quality management systems - Guidelines for quality management in projects 品質管理系統－專案品質管理指導綱要 |
|
|
|
CNS 10915
2018 Edition Level Recorders for Recording Sound Level and/or Vibration Level 聲度、振動位準記錄用位準記錄器 |
|
|
|
CNS 9995
2018 Edition Rubber Vibration Isolators for Bolster Anchors of Railway Rolling Stock 鐵路車輛搖枕錨桿用防振橡膠 |
|
|
|
CNS 14202
2018 Edition Transmission of non-telephone signals - A far end camera control protocol for videoconference using H.224 非電話信號之傳輸–使用 CNS 14153 標準視訊會議的遠端攝影機控制協定 |
|
|
|
CNS 11385
2018 Edition Modified Polyester Insulated Polyamideimide Overcoated Enamelled Copper Wires 變性聚酯絕緣聚亞胺醯胺被覆漆包銅線 |
|
|
|
CNS 13527
2018 Edition Banking and Related Financial Service - Requirements for Message Authentication (Retail) 銀行業和相關金融服務–零售式訊息鑑別需求 |
|
|
|
CNS 8075
2018 Edition Mtheod of Test for Building Components (Concrete Panels for Roofs) 建築用組件（混凝土屋頂嵌板）檢驗法 |
|
|
|
CNS 15660-5
2018 Edition Test conditions for numerically controlled turning machines and turning centres − Part 5: Accuracy of feeds, speeds and interpolations 數值控制車床及車削中心機之試驗條件－ 第5 部:進給、速率及插值之精度 |
|
|
|
CNS 14213-5
2018 Edition Information technology - Open systems interconnection - Procedures for the operation of OSI registration authorities - Part 5: Register of VT control object definitions 資訊技術–開放系統互連–開放系統互連註冊機構作業程序–第５部：虛擬終端機控制物件定義之註冊 |
|
|
|
CNS 14325
2018 Edition Broadband integrated services digital network (B-ISDN)-Digital subscriber signalling system no.2 (DSS 2)-Additional traffic parameters 寬頻整體服務數位網路－第二號數位用戶信號系統－附加訊務參數 |
|
|
|
CNS 2549
2018 Edition Soft Copper Binding Wire 軟銅紮線 |
Translated |
|
|
CNS 8964
2018 Edition Marine Bronze 5 kgf/㎠ Flanged Cocks 船用青銅凸緣旋塞（5 kgf/㎠） |
|
|
|
CNS 9691
2018 Edition Information Processing Systems-Vocabulary ( Part 5 : Representation of Data ) 資訊處理系統–詞彙（第５部：資料之表示方法） |
|
|
|
CNS 15588-4
2018 Edition Electric traction − Rotating electrical machines for rail and road vehicles − Part 4: Permanent magnet synchronous electrical machines connected to an electronic converter 電力牽引－軌道及道路車輛用之旋轉電機－第4部：電子換流器供電之永磁同步電機 |
|
|
|
CNS 15200-8-5
2018 Edition Methods of test for paints – Part 8-5: Evaluation of degradation of paint coatings – Designation of degree of flaking 塗料一般試驗法－第8-5部： 塗膜劣化評估－片狀剝落 |
|
|
|
CNS 62821-1
2018 Edition Halogen-free, low smoke, thermoplastic insulated and sheathed cables of rated voltages up to and including 450/750 V – Part 1: General requirement 額定電壓450/750 V 以下無鹵素低煙量熱塑性絕緣與被覆電纜－第1部：一般規定 |
|
|
|
CNS 15247
2018 Edition Test methods on light emitting diode components and modules (for general lighting service) for normal life 照明用發光二極體元件與模組之一般壽命試驗方法 |
Translated |
|
|
CNS 15468-5-1
2018 Edition Fuel cell technologies - Part 5-1: Portable fuel cell power systems - Safety 燃料電池技術－第5-1部：可攜式燃料電池發電系統－安全 |
|
|
|
CNS 15652-4
2018 Edition Intelligent lighting systems − Part 4: Design guide for field area network 智慧照明系統－ 第4部：場域網路設計指引 |
|
|
|
CNS 1356
2018 Edition Methed of test for residue ash content of pulps, paper and board on ignition at 525℃ 紙漿、紙及紙板灰分試驗法－５２５℃ |
|
|
|
CNS 14865
2018 Edition Packaging-Complete,filled transport packages and unit loads-Horizontal impact tests 包裝貨物與單位裝載之水平衝擊試驗法 |
|
|
|
CNS 14285
2018 Edition Polyethylene Foam for Heat Insulating 聚乙烯絕緣聚氯乙烯被覆﹝PE-PVC﹞引進線 |
|
|
|
CNS 15591-1
2018 Edition Electrical apparatus for use in the presence of combustible dust - Part 1: Protection by enclosures〝tD〞 可燃性粉塵環境用電機設備－第1部：外殼保護〝tD〞 |
|
|
|
CNS 15590-7
2018 Edition Mechanical properties of fasteners – Part 7: Torsional test and minimum torques for bolts and screws with nominal diameters 1 mm to 10 mm 結件之機械性質－第7部：標稱直徑1 mm至10 mm螺栓與螺釘之扭力試驗及最小扭矩 |
|
|
|
CNS 15612
2018 Edition Plastics − Determination of the melt mass-flow rate (MFR) and melt volume-flow rate (MVR) of thermoplastics − Part 1: Standard method 塑膠－吸水率測定法 |
|
|
|
CNS 10059
2018 Edition Nominal Dimensions of Glue Spreaders 佈膠機之標稱尺度 |
|
|
|
CNS 13524
2018 Edition Standard Representation of Latitude, Longitude and Altitude for Geographic Point Locations 地理點位置之經度緯度及海拔高度之標準表示法 |
|
|
|
CNS 15710-4
2018 Edition Effects of current on human beings and livestock – Part 4: Effects of lightning strokes 電流在人體及家畜上之效應－第4 部：雷擊效應 |
|
|
|
CNS 4025
2018 Edition Permissbile Deviations in Dimensions Without Tolerance Indication (Aluminium Alloy Castings) 一般許可差（鋁合金鑄件） |
|
|
|
CNS 15620-4
2018 Edition Insulation coordination for equipment within low-voltage system – Part 4: Considerationof high-frequency voltage stress 低電壓系統下設備之絕緣協調－第4 部：高頻電壓應力之考量 |
|
| Find out:6646Items | To Page of: First -Previous-Next -Last | [100] [101] [102] [103] [104] [105] [106] |
