CNS Standards Solution | HOME | LOGIN | SIGN UP | CONTACT US | 中文版 |

Chinese National Standards
中華民國國家標準
- Taiwan 台灣 -
 

"test " CNS Standards List

Z-#N/A
CNS 15138-1    2012 Edition
Method of test for determination of phthalates plasticizers in plastic products - Part 1: Gas chromatography/mass spectrometry
塑膠製品中鄰苯二甲酸酯類塑化劑檢驗法-氣相層析質譜法

Translated
K-Chemical Industry
CNS 6834-5    2012 Edition
testing methods for rubber and plastics hoses - Part 5: Determination of electrical resistance and conductivity
橡膠管及塑膠管試驗法-第5部:電阻與導電係數之測定
C-Electrical Engineering
CNS 15207-10    2012 Edition
Road vehicles - Component test methods for electrical disturbances from narrowband radiated electromagnetic energy - Part 10: Immunity to conducted disturbances in the extended audio frequency range
道路車輛-窄頻輻射電磁能量之電擾動組件試驗法-第10部:音頻延伸範圍之傳導擾動免疫力
K-Chemical Industry
CNS 6834-3    2012 Edition
testing methods for rubber and plastics hoses - Part 3: Determination of resistance to vacuum
橡膠管及塑膠管試驗法-第3部:耐負壓試驗
K-Chemical Industry
CNS 6834-2    2012 Edition
testing methods for rubber and plastics hoses - Part 2: Hydrostatic testing
橡膠管及塑膠管試驗法-第2部:耐靜液壓試驗
K-Chemical Industry
CNS 6834-1    2012 Edition
testing methods for rubber and plastics hoses - Part 1: Methods of measurement of the dimensions of hoses and the lengths of hose assemblies
橡膠管及塑膠管試驗法-第1部:膠管尺度及管組合件長度之量測
B-Mechanical Engineering
CNS 15077-10    2012 Edition
test conditions for machining centres - Part 10: Evaluation of thermal distortions
切削中心機之檢驗條件-第10部:熱變形之評估
S-Domestic Wares
CNS 15562-7    2012 Edition
Stationary training equipment − Part 7: Rowing machines − Additional specific safety requirements and test methods
固定式訓練設備-第7部:划船機-附加之特定安全要求與試驗法
Z-#N/A
CNS 386-1    2012 Edition
test sieves - For construction engineering
試驗篩-營建工程用
C-Electrical Engineering
CNS 15620-1    2012 Edition
Insulation coordination for equipment within low-voltage system – Part 1: Principles, requirements and tests
低電壓系統下設備之絕緣協調-第1部:原理、要求及試驗
K-Chemical Industry
CNS 6834-6    2012 Edition
testing methods for rubber and plastics hoses - Part 6: Determination of adhesion between components
橡膠管及塑膠管試驗法-第6部:層間接著強度之測定
A-Civil Engineering & Architecture
CNS 15518    2011 Edition
Method of test for preblended dry mortar mix
普通預拌乾混水泥砂漿料試驗法
H-Non-ferrous Materials & Metallurgy
CNS 15495    2011 Edition
test methods of tensile adhesive strength for thermal-sprayed coatings
熔射塗層拉伸附著強度試驗法
C-Electrical Engineering
CNS 15466    2011 Edition
testing method of performance for air source heat pump water heaters
空氣源式熱泵熱水器之性能試驗法
Q-Environmental Management
CNS 16000-10    2011 Edition
Indoor air - Part 10: Determination of the emission of volatile organic compounds from building products and furnishing - Emission test cell method
室內空氣-第10部:建築產品與家飾逸散揮發性有機化合物之測定-逸散試驗槽法
Q-Environmental Management
CNS 16000-9    2011 Edition
Indoor air - Part 9: Determination of the emission of volatile organic compounds from building products and furnishing - Emission test chamber method
室內空氣-第9部:建築產品與家飾逸散揮發性有機化合物之測定-逸散試驗箱法
A-Civil Engineering & Architecture
CNS 8904    2011 Edition
testing methods of sealants for sealing and glazing in buildings
建築用密封材料試驗法
Q-Environmental Management
CNS 16000-11    2011 Edition
Indoor air - Part 11: Determination of the emission of volatile organic compounds from building products and furnishing - Sampling, storage of samples and preparation of test specimens
室內空氣-第11部:建築產品與家飾逸散揮發性有機化合物之測定-採樣、試樣儲存及試片製備
C-Electrical Engineering
CNS 15194-3    2010 Edition
Road vehicles - Electrical disturbances by narrowband radiated electromagnetic energy - Vehicle test methods - Part 3: On-board transmitter simulation
道路車輛-窄頻輻射電磁能量的電擾動之車輛試驗法-第3部:車載發射機模擬
K-Chemical Industry
CNS 3776    2009 Edition
Method of test for Ramsbottom carbon residue of petroleum products
石油產品藍氏殘碳量試驗法
G-Ferrous Materials & Metallurgy
CNS 15235    2009 Edition
Methods of accelerated cyclic corrosion resistance tests for anodic coatings with exposure to salt spray, dry and wet conditions
陽極被覆鋼板之加速循環腐蝕試驗法
N-Agriculture, Food
CNS 12981    2007 Edition
Method of test for milk and milk products - Determination of fat content in edible cheese
乳品檢驗法-食用乾酪脂肪含量之測定
N-Agriculture, Food
CNS 12980    2007 Edition
Method of test for milk and milk products - Determination of nitrate and nitrite content in edible cheese
乳品檢驗法-食用乾酪硝酸鹽和亞硝酸鹽含量之測定
N-Agriculture, Food
CNS 12957    2007 Edition
Method of test for milk and milk products - Determination of total phosphorus content in edible cheese
乳品檢驗法-食用乾酪總磷含量之測定
N-Agriculture, Food
CNS 12956    2007 Edition
Method of test for milk and milk products - Determination of citric acid content in edible cheese
乳品檢驗法-食用乾酪檸檬酸含量之測定
N-Agriculture, Food
CNS 15091-8    2007 Edition
Method of test for deep sea water - Determination of chlorinity
深層海水檢驗法-氯之測定
N-Agriculture, Food
CNS 15091-18    2007 Edition
Method of test for deep sea water - Determination of bacteria abundance (DAPI)
深層海水檢驗法-總細菌數之測定(DAPI染色法)
N-Agriculture, Food
CNS 15091-17    2007 Edition
Method of test for deep sea water - Determination of total organic carbon
深層海水檢驗法-總有機碳之測定
N-Agriculture, Food
CNS 3455    2007 Edition
Method of test for milk and milk products - Determination of viscosity in condensed milk
乳品檢驗法-煉乳黏度之測定
N-Agriculture, Food
CNS 15091-15    2007 Edition
Method of test for deep sea water - Determination of nitrite
深層海水檢驗法-亞硝酸鹽之測定

Find out:4507Items   |  To Page of: First -Previous-Next -Last  | [119] [120] [121] [122] [123] [124] [125]

 

| HOME | LOGIN | SIGN UP | CONTACT US | 中文版 | ©  CNS-standards.org Copyright  2001-2025 All Rights Reserved
The authority agency link :
Bureau of Standards, Metrology & Inspection M.O.E.A.
This site is not affiliated with or endorsed by the BSMI or MOEA.