"Part " CNS Standards List |
|
CNS 14934-5
2019 Edition Electromagnetic compatibility (EMC) - Limits - Part 5: Limitation of voltage fluctuations and flicker in low-voltage power supply systems for equipment with rated current greater than 16A 電磁相容－限制值－第5部：額定電流大於16 A之設備於低電壓電源系統中電壓變動及閃爍之限制值 |
|
|
|
CNS 14958-1
2019 Edition Human exposure to radio frequency fields from hand-held and body-mounted wireless communication devices – Human models, instrumentation, and procedures – Part 1: Procedure to determine the specific absorption rate (SAR) for hand-held devices used in close 人體曝露於手持式及佩戴式無線裝置之射頻場－人體模型、儀器及程序－第１部︰使用時靠近耳朵之手持式裝置（頻率介於３００ＭＨｚ至３ＧＨｚ）之比吸收率（ＳＡＲ）量測程序 |
Translated |
|
|
CNS 8912
2019 Edition Method of abrasion test for building materials and Part of building construction (Method of abrasion test for flooring materials method with rotating disk fitted friction and impact) 建築材料及建築組件磨耗試驗法(旋轉圓盤之摩擦及衝擊地板材料之磨耗試驗法) |
|
|
|
CNS 15659-2
2019 Edition Evaluation of moisture-absorbing and quick-drying properties in textiles − Part 2: Moisture management test 紡織品吸濕速乾性能評估－第2 部：水分傳導試驗法 |
|
|
|
CNS 16108-1
2019 Edition Railway applications − Fire protection on railway vehicles − Part 1: General 鐵路應用－鐵路車輛防火－第1部：通則 |
|
|
|
CNS 60245-8
2019 Edition Rubber insulated cables − Rated voltages up to and including 450/750 V − Part 8: Cords for applications requiring high flexibility 額定電壓450/750 V 以下橡膠絕緣電纜－第8部：高可撓性用途花線 |
|
|
|
CNS 15515-2
2019 Edition Electrically propelled road vehicles – Test specification for lithium-ion traction battery packs and systems – Part 2: High-energy applications 電動推進道路車輛－鋰離子牽引電池組及系統之試驗規範－第2 部：高電能量應用 |
|
|
|
CNS 3376-7
2019 Edition Explosive atmospheres - Part 7: Equipment protection by increased safety〝e〞 爆炸性環境－第７部：增加安全構造〝ｅ〞之設備保護 |
|
|
|
CNS 14545-8
2019 Edition Fire hazard testing-Part 2:Test methods-Section 2:Needle-flame test 火災危險性試驗－第２部：試驗方法－第２章：針焰試驗 |
|
|
|
CNS 12628
2019 Edition Plastics − Unplasticized poly (vinyl chloride) sheets − Part 2: Types, dimensions and characteristics for sheets of thickness less than 1 mm 塑膠及硬橡膠－彈簧式硬度計之凹壓硬度(蕭氏硬度)測定法 |
|
|
|
CNS 62552-3
2019 Edition Household refrigerating appliances − Characteristics and test methods − Part 3: Energy consumption and volume 家用冷凍冷藏電器－特性及試驗法－第3部：消耗電量及容積 |
|
|
|
CNS 29182-5
2019 Edition Information technology − Sensor networks: Sensor Network Reference Architecture (SNRA) − Part 5: Interface definitions 資訊技術－感測器網路：感測器網路參考架構(SNRA)－第5部：介面定義 |
|
|
|
CNS 14545-4
2019 Edition Fire hazard testing-Part 2:Test methods-Section 1/sheet 0:Glow-wire test methods-General 火災危險性試驗－第２部：試驗方法－第１章／第０單元：熾熱線試驗方法－通則 |
|
|
|
CNS 14374
2019 Edition Method of test for cigarettes -Determination of total and nicotine - free dry Particulate matter 捲菸檢驗法－總粒狀物及不含尼古丁乾粒狀物之測定 |
|
|
|
CNS 15077-5
2019 Edition Test conditions for machining centers - Part 5 : Accuracy and repeatability of positioning of work-holding pallets 切削中心機之檢驗條件－第５部：工件夾持托板之定位精度與重現性 |
|
|
|
CNS 15776-2
2019 Edition Energy management system application program interface (EMS-API) – Part 2: Glossary 能源管理系統應用程式介面－第2部：詞彙 |
|
|
|
CNS 15200-1-6
2019 Edition Testing methods for paints - Part 1-6: General rule - Temperatures and humidities for conditioning and testing 塗料一般試驗方法－第１－６部：通則－調節與試驗之溫度及濕度 |
|
|
|
CNS 14934-4
2019 Edition Electromagnetic compatibility (EMC) - Limits - Part 4: Limitation of emission of harmonic current in low-voltage power supply systems for equipment with rated current greater than 16A 電磁相容－限制值－第4部：額定電流大於16 A之設備於低電壓電源系統中諧波電流發射之限制值 |
|
|
|
CNS 20349-2
2019 Edition Personal protective equipment − Footwear protecting against risks in foundries and welding − Part 2: Requirements and test methods for protection against risks in welding and allied processes 個人防護具－防止鑄造及熔接中風險之鞋類－第2部：防護熔接及類似製程風險之要求事項及試驗方法 |
|
|
|
CNS 15760-2
2019 Edition Footwear − General test methods – Part 2: Sampling location, preparation and duration of conditioning of samples and test pieces 鞋類－ 一般試驗法－ 第2 部： 樣品與試片之取樣部位、製備及狀態調節時間 |
|
|
|
CNS 14432-2
2019 Edition Determination of the ultimate aerobic biodegradability of plastic materials under controlled composting conditions − Method by analysis of evolved carbon dioxide − Part 2: Gravimetric measurement of carbon dioxide evolved in a laboratory-scale test 塑膠材料在控制堆肥條件下最終好氧生物分解度測定法－二氧化碳釋出量分析法－第2部：實驗室規模重量測定法 |
|
|
|
CNS 13306-1-5
2019 Edition Specification for radio disturbance and immunity measuring apparatus and methods - Part 1-5: Radio disturbance and immunity measuring apparatus - Antenna calibration test sites for 30 MHz to 1000 MHz 射頻擾動和免疫力量測設備與量測方法－第１－５部：射頻擾動和免疫力量測設備－30 MHz至 1000 MHz之天線校正場地 |
|
|
|
CNS 15077-8
2019 Edition Test conditions for machining centers - Part 8 : Evaluation of contouring performance in the three coordinate planes 切削中心機之檢驗條件－第８部：在三個坐標平面內之輪廓性能評估 |
|
|
|
CNS 60245-7
2019 Edition Rubber insulated cables − Rated voltages up to and including 450/750 V − Part 7: Heat resistant ethylene-vinyl acetate rubber insulated ables 額定電壓450/750 V 以下橡膠絕緣電纜－ 第7部：耐熱乙烯-醋酸乙烯酯橡膠絕緣電纜 |
|
|
|
CNS 15746-2
2019 Edition Textile slings − Safety − Part 2: Roundslings, made of man-made fibres for general purpose use 紡織吊帶－安全－第2 部:一般用人造纖維製圓帶 |
|
|
|
CNS 13306-1-1
2019 Edition Specification for radio disturbance and immunity measuring apparatus and methods - Part 1-1: Radio disturbance and immunity measuring apparatus - Measuring apparatus 射頻擾動和免疫力量測設備與量測方法－第１－１部：射頻擾動和免疫力量測設備－量測設備 |
|
|
|
CNS 15748-4
2019 Edition Integrated Circuits – Measurement of electromagnetic emissions, 150 kHz to 1 GHz – Part 4: Measurement of conducted emissions – 1 Ω/150 Ω direct coupling method 積體電路－150 kHz 至1 GHz 電磁放射量測－第4 部：傳導放射量測－1Ω/150Ω直接耦合法積體電路－150 kHz 至1 GHz 電磁放射量測－第4 部：傳導放射量測－1Ω/150Ω直接耦合法 |
|
|
|
CNS 15125-2
2019 Edition Solar heating - Domestic water heating systems - Part 2 : Outdoor test methods for system performance characterization and yearly performance prediction of solar-only systems 太陽能加熱－家用熱水系統－第２部：僅用太陽能系統的性能特性與年度性能預測之室外試驗法 |
|
|
|
CNS 16121-1
2019 Edition Electrical apparatus for the detection of combustible gases in domestic premises − Part 1: Test methods and performance requirements 家居處所可燃氣體偵測用之電氣裝備－第1部：試驗方法及性能要求 |
|
|
|
CNS 14705-3
2019 Edition Method of test for heat release rate for building materials − Part 3: Guidance on measurement 建築材料燃燒熱釋放率試驗法－第3 部：量測之指引 |
|
| Find out:2535Items | To Page of: First -Previous-Next -Last | [24] [25] [26] [27] [28] [29] [30] |
