"Ea " CNS Standards List |
|
CNS 2185
2018 Edition Polyurethane ClEar Coating 聚胺酯漆包銅線 |
Translated |
|
|
CNS 14327-1
2018 Edition Digital subscriber signalling system no.2-Connection modification:PEak cell rate modification by the connection owner 第二號數位用戶信號系統－連接修改：由連接擁有者從事之尖峰細胞速率修改 |
|
|
|
CNS 15652-3
2018 Edition Intelligent lighting systems − Part 3: Field arEa network interface 智慧照明系統－ 第3部：場域網路介面 |
|
|
|
CNS 14344
2018 Edition Fittings for wEathertight steel doors (Rectangular corner type) 船用鋼質風雨密門（方角型）裝具 |
|
|
|
CNS 15620-5
2018 Edition Insulation coordination for equipment within low-voltage system – Part 5: Comprehensive method for determining clEarance and creepage distances equal to or less than 2 mm 低電壓系統下設備之絕緣協調－第5 部： 決定2 mm 以下空間距離及沿面距離之詳盡方法 |
|
|
|
CNS 13483
2018 Edition Method of Test for BrEaking Load and Elongation of Geotextiles (Grab Method) 地工織物抗拉強度及伸長率試驗法（抓式法） |
|
|
|
CNS 15176-21
2018 Edition Wind turbines − Part 21: MEasurement and assessment of power quality characteristics of grid connected wind turbines 風力機－第21 部：併網型風力機之電力品質特性量測與評鑑 |
|
|
|
CNS 9137
2018 Edition 250V Single-Core, Twin-Core Three-Core ERR Insulated PVE ShEathed Cable (250V-SPY, 250V-DPY, 250V-TPY) for Marine Use 船用２５０Ｖ單心、二心、三心ＥＰＲ絕緣ＰＶＣ被覆電纜（２５０Ｖ–ＳＰＹ，２５０Ｖ–ＤＰＹ，２５０Ｖ–ＴＰＹ） |
|
|
|
CNS 13938-2
2018 Edition Identification cards - Contactless integrated circuit(s) cards; Part 2: Dimensions and location of coupling arEas 識別卡–無接點ＩＣ卡；第２部：耦合區的尺寸與位置 |
|
|
|
CNS 4735-1
2018 Edition 50Ω and 75Ω radio-frequency coaxial cables Part 1：General requirements and mEasuring methods 50Ω及75Ω射頻同軸電纜－第1部：通則與測試方法 |
|
|
|
CNS 12050
2018 Edition HEat resistant glass wares 耐熱玻璃製食品器具 |
|
|
|
CNS 11010
2018 Edition Electric storage tank water hEaters 貯備型電熱水器 |
Translated |
|
|
CNS 10059
2018 Edition Nominal Dimensions of Glue SprEaders 佈膠機之標稱尺度 |
|
|
|
CNS 12451
2018 Edition Methods for MEasuring Specific Gravity of Solid 固體比重測定法 |
|
|
|
CNS 9133
2018 Edition 660V Twin-Core EPR Insulated LEad Sheathed Metal Netting Covered Cable(660V-DPLC) and 660V Twin-core EPR Insulated Lead Sheathed Metal Netting Covered PVC Anti-Corrosion Cable(660V-DPLCY) for Marine Use 船用６６０Ｖ二心ＥＰＲ絕緣鉛皮被覆金屬網鎧裝電纜（６６０Ｖ–ＤＰＬＣ）及６６０Ｖ二心ＥＰＲ絕緣鉛皮被覆金屬網鎧裝ＰＶＣ防蝕電纜（６６０Ｖ–ＤＰＬＣＹ） |
|
|
|
CNS 9151
2018 Edition 660V, Single-Core, Twin-Core, Three-Core, EPR Insulated PVC ShEathed Metal Netting Covered Cable and 660V, Single-Core, Twin-Core, Three-Core, EPR Insulated PVC Sheathed Metal Netting Covered PVC Anti-Corrosion Cable for Marine Use 船用６６０Ｖ單心、二心、三心ＥＰＲ絕緣ＰＶＣ被覆金屬網鎧裝電纜（附共同遮蔽）及６６０Ｖ單心、二心、三心ＥＰＲ絕緣ＰＶＣ被覆金屬網鎧裝ＰＶＣ防蝕電纜（附共同遮蔽） |
|
|
|
CNS 9153
2018 Edition 660V, Twin-Core, Three-Core EPR Insulated PVC ShEathed Metal Netting Covered Cable and 660V Twin-Core, Three-Core EPR Insulated PVC Sheathed Metal Netting Covered PVC Anti-Corrosion Cable for Marine Use 船用６６０Ｖ二心、三心ＥＰＲ絕緣ＰＶＣ被覆金屬網鎧裝電纜（附各心線個別遮蔽）及６６０Ｖ二心、三心ＥＰＲ絕緣ＰＶＣ被覆金屬網鎧裝ＰＶＣ防蝕電纜（附各心線個別遮蔽） |
|
|
|
CNS 14952-3-1
2018 Edition Guide for the determination of thermal endurance properties of electrical insulating materials - Part 3: Instructions for calculating thermal endurance characteristics - section 1: calculations using mEan values of normally distributed complete data 電氣絕緣材料之耐熱性測定指引－第３部：耐熱特性計算之說明－第１章：利用常態分配完整資料的平均值進行計算 |
|
|
|
CNS 13177
2018 Edition Method of Test for Compressive Strength of Polyester Resin Concrete Using Portions of BEams Broken in Flexure 聚酯樹脂混凝土梁彎曲折斷部分之抗壓強度試驗法 |
Translated |
|
|
CNS 62821-2
2018 Edition Halogen-free, low smoke, thermoplastic insulated and shEathed cables of rated voltages up to and including 450/750 V − Part 2: Test methods 額定電壓450/750 V 以下無鹵素低煙量熱塑性絕緣與被覆電纜－第2部：試驗法 |
|
|
|
CNS 62821-1
2018 Edition Halogen-free, low smoke, thermoplastic insulated and shEathed cables of rated voltages up to and including 450/750 V – Part 1: General requirement 額定電壓450/750 V 以下無鹵素低煙量熱塑性絕緣與被覆電纜－第1部：一般規定 |
|
|
|
CNS 5064
2018 Edition Methods of Luminance MEasurements 輝度測量法 |
|
|
|
CNS 6862
2018 Edition Respiratory protective devices − Self-contained closed-circuit brEathing apparatus compressed oxygen or compressed oxygen-nitrogen type − Requirements, testing, marking 呼吸防護裝置－壓縮氧氣式或壓縮氧氣-氮氣式密閉循環自攜呼吸器－要求、試驗、標示 |
|
|
|
CNS 183
2018 Edition Cylindrical gEars for general and heavy engineering-Modules 一般機械及重機械用圓柱齒輪─模數 |
|
|
|
CNS 9156
2018 Edition 250V,Single-Core,Twin-Core,Three-Core,EPR Insulated CP ShEathed Metal Netting Covered Cable 250V Single-Core Three-Core EPR Insulated CP Sheathed Metal Netting Covered PVC Anti-Corrosion Cable for Marine Use 船用２５０Ｖ單心、二心、三心ＥＰＲ絕緣ＣＰ被覆金屬網鎧裝電纜（附共同遮蔽）及２５０Ｖ單心、二心、三心ＥＰＲ絕緣ＣＰ被覆金屬網鎧裝ＰＶＣ防蝕電纜（附共同遮蔽） |
|
|
|
CNS 11281
2018 Edition Clevis Ping with HEad for Railway Rolling Stock 鐵路車輛用平頭圓銷 |
|
|
|
CNS 14431
2018 Edition Method of test for performance of oil/grEase interceptor 油脂截留器性能試驗法 |
|
|
|
CNS 61347-1
2018 Edition Lamp controlgEar − Part 1: General and safety requirements 光源控制裝置－第1部：通則及安全要求 |
|
|
|
CNS 13940-2
2018 Edition Identification cards - Optical memory cards - LinEar recording method; Part 2: Dimensions and location of the accessible optical area 識別卡–光學記憶卡–線性記錄法；第２部：可存取光學區的尺寸與位置 |
|
|
|
CNS 62133-1
2018 Edition Secondary cells and batteries containing alkaline or other non-acid electrolytes − Safety requirements for portable sEaled secondary cells, and for batteries made from them, for use in portable applications − Part 1: Nickel systems 含鹼性或其他非酸性電解質之二次單電池及電池組－用於可攜式應用之可攜式封裝型二次單電池及由其所組成的電池組之安全要求－第1部：鎳系 |
|
| Find out:3155Items | To Page of: First -Previous-Next -Last | [44] [45] [46] [47] [48] [49] [50] |
