| "test " CNS Standards List| Characteristics a | Oil bitter | Sand Shovel | Crude or | Sterilization health | Method Test | Information technology | Iron ores—Method | | 
| 
 | CNS 14431 
			            2018 Edition Method of test for performance of oil/grease interceptor 油脂截留器性能試驗法 |   | |
| 
 | CNS 15562-5 
			            2018 Edition Stationary training equipment − Part 5: Stationary exercise bicycles and upper body crank training equipment, additional specific safety requirements and test methods 固定式訓練器材-第5部:固定式健身單車及上半身曲柄訓練器材之附加特定安全要求與試驗法 |   | |
| 
 | CNS 12725 
			            2018 Edition Method of test for Determining of Vitamin A Content for Infant Formula 嬰兒配方食品中維生素A含量測定法 |   Translated | |
| 
 | CNS 14952-1 
			            2018 Edition Guide for the determination of thermal endurance properties of electrical insulating materials - Part 1: General guidelines for ageing procedure and evaluation of test results 電氣絕緣材料之耐熱性測定指引-第1部:老化程序與試驗結果評估之一般導引 |   | |
| 
 | CNS 13481 
			            2018 Edition Method of test for Autoclaved Lightweight Aerated Concrete Blocks 高壓蒸氣養護輕質氣泡混凝土磚檢驗法 |   | |
| 
 | CNS 3560 
			            2018 Edition Method of test for compression set of vulcanized or thermoplastic rubber at ambient, elevated or low temperatures 硫化橡膠或熱塑性橡膠壓縮永久變形試驗法 |   | |
| 
 | CNS 13620 
			            2018 Edition Method of test for Potential Alkali Reactivity of Carbonate Rocks for Concrete Aggregates(Rock Cylinder Method) 碳酸鹽質岩石用作混凝土粒料之潛在鹼質反應性試驗法(岩石圓柱體法) |   | |
| 
 | CNS 12382 
			            2018 Edition Method of test for the California Bearing Ratio (CBR) 夯實土樣加州載重比試驗法 |   | |
| 
 | CNS 970 
			            2018 Edition Method of test for Canned Food-Sampling 食品罐頭檢驗法–取樣 |   Translated | |
| 
 | CNS 14280 
			            2018 Edition Method of test for physical performances of building curtain walls - General rule 帷幕牆及其附屬門、窗物理性能試驗總則 |   | |
| 
 | CNS 4339 
			            2018 Edition Method of test for Determining Water Emersion Endurance of Glue Seams of Paper Sacks 紙袋膠縫耐水浸潤時間之試驗法 |   | |
| 
 | CNS 15562-1 
			            2018 Edition Stationary training equipment − Part 1: General safety requirements and test methods 固定式訓練器材-第1部:一般安全要求與試驗法 |   | |
| 
 | CNS 13300 
			            2018 Edition Method of test for Tensile Properties of Geotixtiles by the Wide - Width Strip 地工織物抗拉力試驗法(寬幅法) |   | |
| 
 | CNS 4705 
			            2018 Edition Method of test for Photoelectric Controls for Public Lighting 路燈用光電式自動點滅器檢驗法 |   Translated | |
| 
 | CNS 973 
			            2018 Edition Method of test for Canned Food-Inspection for Interior of Can 食品罐頭檢驗法–罐內壁檢查 |   Translated | |
| 
 | CNS 450 
			            2018 Edition Wood - Sampling methods and general requirements for physical and mechanical tests 木材之物理與強度試驗之取樣方法與一般要求 |   | |
| 
 | CNS 919 
			            2018 Edition Method of test for Ammonium Sulfate 硫酸銨檢驗法 |   Translated | |
| 
 | CNS 1910 
			            2018 Edition Pylon Slalom test Procedure for Passenger Car and Light Trailer Combination 吡啶(試藥) |   | |
| 
 | CNS 12723 
			            2018 Edition Method of test for Determining of Vitamin E Content for Infant Formula 嬰兒配方食品中維生素E含量測定法 |   Translated | |
| 
 | CNS 3517 
			            2018 Edition Method of test for water in petroleum products and bituminous materials by distillation 石油產品與瀝青類物質 水分試驗法(蒸餾法) |   | |
| 
 | CNS 10367 
			            2018 Edition Method of test for oversized particles in emulsified bitumen (Sieve test) 乳化瀝青篩析試驗法 |   | |
| 
 | CNS 6358 
			            2018 Edition Method of test for water and sediment in fuel oils by the centrifuge method 燃料油水分與沈澱物試驗法 (離心法) |   | |
| 
 | CNS 6866 
			            2018 Edition Method of test for Delivery Rate of Aerosol Products 噴霧性產品之噴出率檢驗法 |   Translated | |
| 
 | CNS 2620 
			            2018 Edition Method of test for Phosphoric Acid (for Industrial Use) 磷酸(工業用)檢驗法 |   Translated | |
| 
 | CNS 15200-8-3 
			            2018 Edition Methods of test for paints – Part 8-3: Evaluation of degradation of paint coatings – Designation of degree of rusting 塗料一般試驗法-第8-3部: 塗膜劣化評估-銹蝕等級 |   | |
| 
 | CNS 14600 
			            2018 Edition Classification and testing methods for deposited metal of stainless steel by submerged arc welding 不銹鋼潛弧銲接之熔填金屬分類及試驗法 |   | |
| 
 | CNS 13298 
			            2018 Edition Method of test for Water Permeability of Geotextiles by Permittivity 地工織物正向透水率試驗法 |   | |
| 
 | CNS 14637-3 
			            2018 Edition test code for machine tools − Part 3: Determination of thermal effects 工具機試驗規範-第3部:熱效應之決定 |   | |
| 
 | CNS 15606-3 
			            2018 Edition Plastics − Determination of tensile properties − Part 2: test conditions for moulding and extrusion plastics 塑膠-抗拉性能測定法-第3部: 膜與片之試驗條件 |   | |
| 
 | CNS 12724 
			            2018 Edition Method of test for Determining of Vitamin E Content for Foodstuff 食品中維生素E含量測定法 |   Translated | 
| Find out:4507Items | To Page of: First -Previous-Next -Last | [65] [66] [67] [68] [69] [70] [71] | 



