"1,2 " CNS Standards List |
|
CNS 12852
2021 Edition Packaged drinking water 包裝飲用水 |
Translated |
|
|
CNS 12835-1
2021 Edition Plastics piping systems for soil and waste discharge inside buildings − Polyethylene (PE) 燃氣用塑膠配管系統－聚乙烯(PE)－第1 部：通則 |
|
|
|
CNS 12491-7
2021 Edition Graphical Symbols for Use on Electrical and Electronic Equipment (Radar Control Desk,Radio Direction Finder) 電機電子設備用圖符號（雷達控制台，無線電測向儀） |
|
|
|
CNS 12149
2021 Edition Sport Drinks ( Packaged ) 運動飲料（已包裝） |
Translated |
|
|
CNS 15827-50
2021 Edition Safety rules for the construction and installation of lifts – Examinations and tests – Part 50: Design rules, calculations, examinations and tests of lift components 升降機結構及安裝之安全總則－檢驗及試驗－第50 部：升降機構件之設計規則、計算、檢驗及試驗 |
|
|
|
CNS 11263
2021 Edition Methods of test for spun yarn 紡製紗支試驗法 |
|
|
|
CNS 12392
2021 Edition Method of Test for Nonrepetitive Static Plate Load of Soils and Flexible Pavement Components, for Use in Evaluation and Design of Airport and Highway Pavement 土壤與柔性舖面之非反覆式靜力平板載重試驗法（應用於機場與公路舖面之設計與評估） |
|
|
|
CNS 12491-14
2021 Edition Graphical Symbols for Use on Electrical and Electronic Equipment (Image) 電機電子設備用圖符號（影像） |
|
|
|
CNS 13629
2021 Edition Polybutylene (PB) plastics piping systems for hot and cold water installations - Part 7: Guidance for the assessment of conformity 聚碳酸酯成形材料 |
Translated |
|
|
CNS 15700-3-1
2021 Edition Plugs, socket-outlets, vehicle connectors and vehicle inlets – Conductive charging of electric vehicles – Part 2: Dimensional compatibility and interchangeability requirements for a.c. pin and contact-tube accessories + Amendment 1 電源端插頭、電源端插座、車輛端插頭及車輛端插座－電動車輛傳導式充電－第3-1部：使用熱管理系統之直流充電用車輛端插頭、車輛端插座及纜線組 |
|
|
|
CNS 15910-2
2021 Edition Pressure sore prevention mattress for home use − Part 1: Types 家用之褥瘡防止鋪墊－第2 部：替換靜態型 |
|
|
|
CNS 12491-2
2021 Edition Graphical Symbols for Use on Electrical and Electronic Equipment (General) 電機電子設備用圖符號（一般） |
|
|
|
CNS 14705-2
2021 Edition Method of test for heat release rate for building materials – Part 2: Smoke production rate (dynamic measurement) 建築材料燃燒熱釋放率試驗法－第2 部：煙產生率(動態檢測) |
|
|
|
CNS 15391-2
2021 Edition Secondary batteries for the propulsion of electric road vehicles - Part 2: Reliability and abuse testing for lithium-ion cells 電動車輛推進用二次電池組－第2部：鋰離子單電池之可靠度及異常使用效應測試 |
|
|
|
CNS 15832-4-1
2021 Edition Method of test for paint components − Part 4-1: Analysis for components emitted from film − Determination of formaldehyde emission 塗料成分試驗法－第4-1 部：塗膜釋出成分分析－甲醛釋出量之測定 |
|
|
|
CNS 15814-2
2021 Edition Fire tests for building elements and components – Fire testing of service installations – Part 2: Linear joint (gap) seals 建築構件與零組件防火試驗－ 配管設置防火測試－ 第2 部：線形接合(縫隙)密封部 |
|
|
|
CNS 12620
2021 Edition Method of eddy current test for steel pipes and tubes 鋼管渦電流檢測法 |
|
|
|
CNS 15852-1
2021 Edition Thermoplastics pipes, fittings and assemblies for the conveyance of fluids − Determination of the resistance to internal pressure − Part 1: General method 流體輸送用熱塑性塑膠管、管件及組合件－耐內壓力測定－第1 部：一般方法 |
|
|
|
CNS 15700-2
2021 Edition Plugs, socket-outlets, vehicle connectors and vehicle inlets – Conductive charging of electric vehicles – Part 2: Dimensional compatibility and interchangeability requirements for a.c. pin and contact-tube accessories + Amendment 1 電源端插頭、電源端插座、車輛端插頭及車輛端插座－電動車輛傳導式充電－第2部：針對交流刃片及導電嘴配件之尺度相容性及互換性要求(補充增修1) |
|
|
|
CNS 13333-2
2021 Edition Plastics − Methods for determining the density of non-cellular plastics − Part 1: Immersion method, liquid pyknometer method and titration method 塑膠－非發泡塑膠之密度測定法－第2 部：密度梯度管柱法 |
|
|
|
CNS 12460
2021 Edition Method of Test for Piles Under Static Axial Compressive Load 基樁軸向靜壓載重試驗法 |
|
|
|
CNS 13802-6
2021 Edition Graphical Symbols for Diagrams (Production and Conversion of Electrical Energy) 電機工程製圖符號（電能之產生及轉換） |
|
|
|
CNS 12393
2021 Edition Method of Test for Repetitive Static Plate Load of Soils and Flexible Pavement Components, for Use in Evaluation and Design of Airport and Highway Pavement 土壤與柔性舖面之反覆式靜力平板載重試驗法（應用於機場與公路舖面之設計與評估） |
|
|
|
CNS 12386
2021 Edition Method of Practice for Thin-Walled Tube Sampling of Soils 土壤薄管取樣法 |
|
|
|
CNS 2901
2021 Edition Small and medium alternating current synchronous generator 中小型交流同步發電機 |
Translated |
|
|
CNS 11526
2021 Edition Method of test for wind resistance of windows and doors 門窗抗風壓性試驗法 |
|
|
|
CNS 10210
2021 Edition Method of Test for Gaskets for Windows, Doors and Joints of Panel in Buildings 建築用墊條檢驗法 |
|
|
|
CNS 12638
2021 Edition Method of test for fruit and vegetable juices and drinks－Determination of sodium,potassium,calcium and magnesium by atomic absorption spectrophotometry 水果及蔬菜汁飲料檢驗法－鈉、鉀、鈣、鎂之測定（原子吸收光譜法） |
|
|
|
CNS 4291
2021 Edition Pressure sensitive adhesive polyvinyl chloride tapes for corrosion protection 包裝用感壓性聚氯乙烯黏膠帶 |
|
|
|
CNS 3299-10
2021 Edition Methods of test for ceramic tiles - Part 10: Determination of chemical resistance 陶瓷面磚試驗法－第10部：耐藥品性試驗法 |
|
| Find out:4607Items | To Page of: First -Previous-Next -Last | [4] [5] [6] [7] [8] [9] [10] |
