"pO " CNS 標準清單

CNS 10204:2019 - 英文版
消防緊急用自備發電設備檢驗法
Method of Test for Fire Fighting Emergency Power Source - English Version

CNS 16080:2019 - 英文版
一次及二次鋰單電池或電池組之運輸安全－試驗法與要求
Safety of primary and secondary lithium cells or batteries during transport ? Test methods and requirements - English Version

A-土木工程及建築

CNS 1234:2019 - 英文版
混凝土抗彎強度試驗法（中心點載重法）
Method of Test for Flexural Strength of Concrete (Using Simple Beam with Center-point Loading) - English Version

已翻譯

K-化學工業

CNS 6577:2019 - 英文版
精油—凝固點測定法
Essential oils - Determination of freezing point - English Version

K-化學工業

CNS 3276:2019 - 英文版
聚甲基丙烯酸甲酯樹脂波形板檢驗法（吸水率測定法）
Method of Test for Polymethylacrylate Corrugated Sheet (Water Absorption) - English Version

已翻譯

L-紡織工業

CNS 1494-8:2019 - 英文版
紡織品－耐家庭與商用洗滌色牢度試驗法－無磷酸鹽標準清潔劑與低溫漂白活化劑
Textiles-Colour fastness to domestic and commercial laundering using a non-phosphate reference detergent incorporating a low temperature bleach activator - English Version

L-紡織工業

CNS 7269:2019 - 英文版
聚丙烯繩索
Polypropylene band - English Version

已翻譯

C-電機工程, 電子工程

CNS 14843-2:2019 - 英文版
不斷電系統（ＵＰＳ)－第１部：使用於限制觸及區之不斷電系統安全通則
Uninterruptible power systems (UPS)－Part 1 : General and safety requirements for UPS used in restricted access location - English Version

已翻譯

C-電機工程, 電子工程

CNS 6070:2019 - 英文版
電機器具用600 V 聚氯乙烯絕緣電線
600 V Polyvinyl chloride insulated wire for electrical apparatus - English Version

K-化學工業

CNS 15039-2:2019 - 英文版
油漆與清漆－揮發性有機化合物含量之測定－第2部：氣相層析法
Paints and varnishes ? Determination of volatile organic compound (VOC) content ? Part 2: Gas-chromatographic method - English Version

K-化學工業

CNS 15053:2019 - 英文版
生質柴油（脂肪酸甲酯）－鉀含量測定法（原子吸收光譜法）
Biodiesel - Fatty acid methyl esters (FAME) - Determination of potassium content by atomic absorption spectrometry - English Version

L-紡織工業

CNS 1494-9:2019 - 英文版
紡織品－耐家庭與商用洗滌色牢度試驗法－無磷酸鹽標準清潔劑合併低溫漂白活化劑使用之氧化漂白反應
Textiles-Colour fastness to domestic and commercial laundering-Oxidative bleach response using a non-phosphate reference detergent incorporating a low temperature bleach activator - English Version

B-機械工程

CNS 7779-4:2019 - 英文版
工業用風機－在標準化實驗室條件下風機聲功率位準測定－第4部：聲強度法
Industrial fans – Determination of fan sound power levels under standardized laboratory conditions – Part 4: Sound intensity method - English Version

B-機械工程

CNS 15077-5:2019 - 英文版
切削中心機之檢驗條件－第５部：工件夾持托板之定位精度與重現性
Test conditions for machining centers - Part 5 : Accuracy and repeatability of positioning of work-holding pallets - English Version

K-化學工業

CNS 5217:2019 - 英文版
輪胎翻修與修補用混合膠料
Compounded rubber for tire retread and repair - English Version

C-電機工程, 電子工程

CNS 14934-5:2019 - 英文版
電磁相容－限制值－第5部：額定電流大於16 A之設備於低電壓電源系統中電壓變動及閃爍之限制值
Electromagnetic compatibility (EMC) - Limits - Part 5: Limitation of voltage fluctuations and flicker in low-voltage power supply systems for equipment with rated current greater than 16A - English Version

Z2-工業安全

CNS 15746-2:2019 - 英文版
紡織吊帶－安全－第2 部:一般用人造纖維製圓帶
Textile slings ? Safety ? Part 2: Roundslings, made of man-made fibres for general purpose use - English Version

K-化學工業

CNS 15040:2019 - 英文版
塗料與清漆－低ＶＯＣ乳膠漆（罐內ＶＯＣ）揮發性有機化合物含量之測定
Paints and varnishes - Determination of the volatile organic compound content of low - VOC emulsion paints (in-can VOC) - English Version

K-化學工業

CNS 15754:2019 - 英文版
建築物內污水排放塑膠配管系統－聚乙烯(PE)
Plastics piping systems for non-pressure underground drainage and sewerage ? Polyethylene (PE) - English Version

C-電機工程, 電子工程

CNS 14958-1:2019 - 英文版
人體曝露於手持式及佩戴式無線裝置之射頻場－人體模型、儀器及程序－第１部︰使用時靠近耳朵之手持式裝置（頻率介於３００ＭＨｚ至３ＧＨｚ）之比吸收率（ＳＡＲ）量測程序
Human exposure to radio frequency fields from hand-held and body-mounted wireless communication devices – Human models, instrumentation, and procedures – Part 1: Procedure to determine the specific absorption rate (SAR) for hand-held devices used in close - English Version

已翻譯

Z5-物流及包裝

CNS 6864:2019 - 英文版
危險物運輸標示
Lables for the transport of dangerous goods - English Version

C-電機工程, 電子工程

CNS 13306-1-3:2019 - 英文版
射頻擾動和免疫力量測設備與量測方法－第１－３部：射頻擾動和免疫力量測設備－輔助設備－擾動功率
Specification for radio disturbance and immunity measuring apparatus and methods - Part 1-3: Radio disturbance and immunity measuring apparatus - Ancillary equipment - Disturbance power - English Version

C-電機工程, 電子工程

CNS 11359:2019 - 英文版
聚乙烯(交連聚乙烯)絕緣聚氯乙烯(聚乙烯)被覆耐火電纜
Polyethylene - aluminum - polyethylene pipes for water works - English Version

K-化學工業

CNS 14949:2019 - 英文版
汽油組成分測定法(高解析毛細管柱氣相層析法)
Method of test for the determination of individual components in spark ignition engine fuels by 100 metre capillary (with precolumn) high-resolution gas chromatography - English Version

C-電機工程, 電子工程

CNS 14934-4:2019 - 英文版
電磁相容－限制值－第4部：額定電流大於16 A之設備於低電壓電源系統中諧波電流發射之限制值
Electromagnetic compatibility (EMC) - Limits - Part 4: Limitation of emission of harmonic current in low-voltage power supply systems for equipment with rated current greater than 16A - English Version

S-日常用品

CNS 15760-1:2019 - 英文版
鞋類－一般試驗法－第1 部：鞋類與鞋類部件狀態調節及測試之標準大氣狀態
Footwear – General test methods – Part 1: Standard atmospheres for conditioning and testing of footwear and components for footwear - English Version

K-化學工業

CNS 15200-9-2:2019 - 英文版
塗料一般試驗法－第9-2 部：粉體塗料－斜面流動性試驗
Methods of test for paints – Part 9-2: Coating powders – Inclined-plane flow test - English Version

K-化學工業

CNS 15110:2019 - 英文版
汽油碳氫化合物類型、含氧化物及苯含量測定法（多維管柱系統式氣相層析法）
Method of test for hydrocarbon types, oxygenated compounds and benzene in spark ignition engine fuels by multi-dimensional gas chromatography - English Version

K-化學工業

CNS 12628:2019 - 英文版
塑膠及硬橡膠－彈簧式硬度計之凹壓硬度(蕭氏硬度)測定法
Plastics ? Unplasticized poly (vinyl chloride) sheets ? Part 2: Types, dimensions and characteristics for sheets of thickness less than 1 mm - English Version

L-紡織工業

CNS 7272:2019 - 英文版
聚丙烯繩索檢驗法
Method of Test for Polypropylene Ropes - English Version

找到:2014條目 | [首頁]-[上一頁]-[下一頁]-[尾頁] | 去到: [18] [19] [20] [21] [22] [23] [24]

﹛	﹛
Chinese National Standards 中華民國國家標準 - Taiwan 台灣 -